Product Description:
- Cobalt Zirconia Clean Gel is used as a non-abrasive surface cleaner for zirconia restorations after the restoration is tried in the patient’s mouth. This gel removes phosphate contamination from the restoration surface that was created during the try-in procedure, allowing for reliable results with adhesive cements.
- This gel can be used to clean the internal surface of ceramic, zirconia, and metal restorations against intraoral examination and contamination with saliva.
Method of use:
Use in non-etchable restorations (zirconia, metal)
After trialing the restoration in the patient’s mouth, rinse it with water and dry it with a blow dryer. Coat the inner surface of the restoration with gel and allow it to set for 20 seconds. Rinse the restoration thoroughly with water and sandblast it if it has not been sandblasted before. Prepare the bonding surface of the restoration with a suitable primer based on the method of use of the material.
Clinical tips when working with Zirconia Cleaner:
- If you are forced to use Zirclean after preparing the restoration surface with Silane or any other primer, repeat the surface preparation steps.
- This product is designed for extraoral use only.
- Be sure to read the instruction manual carefully before use.
- Use gloves when handling.
- If the gel is difficult to get out of the syringe, replace your needle tip.
- After working with the product, close the lid and prevent moisture from entering the syringe.
Warnings:
- Never use this product in a patient’s mouth or on enamel or dentin. This product cannot be used as an enamel or dentin etchant.
- Avoid contact of this product with skin and in case of accidental contact with any body tissue, wash it immediately with plenty of water.
- If this product accidentally gets into the eyes, rinse the eyes thoroughly with plenty of water and seek medical attention immediately.
- Avoid inhaling vapors from this product.
- The best time to use is 24 months after the production date.
Storage conditions:
Please store at 20-25°C. Refrigeration in tropical areas will help extend the shelf life of the product.
Production of Fartak Andishe Borna Company, Iran, Tehran, Enghelab Street, Tehran University of Medical Sciences Campus, Dental Materials and Equipment Development Center, 1st Floor – Fartak Andishe Borna Company
